Waveware Repeater Manuel d'utilisateur télécharger pdf (Page 17)

TRANSMITTER PROGRAMMING SOFTWARE

Repeater Programming

July 16, 2009 15

REPEATER

 Layer

To set the capcode for Multi-layer repeating. Enter “0” for single layer and “1~7”

for multi-layer repeating.

For multi-layer repeating, “1” means the first layer is the master repeater. Only

the master repeater can receive signals from the transmitter. Then it will repeat

the signals to the next layer “2” and so on.

Note: after rebooting your repeater, the TX LED will flash according to the

number of the layers of the repeater.

 S_RSSI

 S_RSSI

It will trigger repeating when the RSSI is below this value. Please refer to pager 6

for instructions on how to set the S_RSSI value.

 Setting

 Invert Polarity (TX/RX)

Choose to Invert Polarity.

 Baud Rate (TX/RX)

POCSAG Signal Baud Rate.

1 2 ... 12 13 14 15 16 17 18

Pas de commentaire

Waveware Repeater Manuel d'utilisateur Page 17