WaveWare Apollo T-2000 Informations techniques télécharger pdf (Page 49)

Certification Manual

- 49 -

Figure 17: AllCall© Bed Station Schematic

AllCall© Bath Station

The AllCall© Bath Station, is very similar to the

Bed Station in that it uses the same plastic enclosure

and wireless transmitter. At that point, however the

similarity ends. As can be seen in the illustration, the

Bath Station is activated by pulling the string. When

the slide switch moves to the alarm position (down),

the red LED comes on and shows the call station to

be in alarm. Once the resident’s need is handled, the

slide switch is then firmly pushed back to the reset

position (up).

The slide switch is single pull, double throw and it is mounted in a

Tektone Faceplate. One side of the switch controls the wireless transmitter,

and the other side controls the LED. On the inside of the Call Station box,

there are two primary components, a wireless transmitter and a LED

battery board. The transmitter controls the communication with the control

This area is reserved for Figure 17

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 113 114

Pas de commentaire

WaveWare Apollo T-2000 Informations techniques Page 49