WaveWare Apollo T-2000 Informations techniques télécharger pdf (Page 72)

Certification Manual

- 72 -

Setting a Dynamic IP Address

Step 1 – Follow all of the above steps until step 3. In the screen

labeled “Internet Protocol (TCP/IP)” click the radio button

labeled “Obtain an IP Address Automatically”.

Step 2 – Click OK in all screens.

Step 3 – In the Local Area Network Screen click the “Support” tab

and the new dynamic IP address will be shown.

Changing a Serial Port Number

Many of the hardware devices that Alliance interfaces with the

computer require the use of a serial DB9 (9 pin connector) port. It is often

important to change the serial port numbers for installation and

troubleshooting purposes.

Changing a serial port number

Step 1 – Go to the following location My Computer / Properties /

Hardware tab / Device Manager / Expand the tree labeled

“Ports”

Step 2 – Double click on the port to be changed, than Click on the

“Port Settings” tab than click “Advanced”

Step 5 – Change the port number to the new desired number.

Note, it is not possible to change a port number to a number that is

already in use.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 113 114

Pas de commentaire

WaveWare Apollo T-2000 Informations techniques Page 72